![background image](http://html2.mh-extra.com/html/icom/ic-7100/ic-7100_instruction-manual_3605333028.webp)
4
RECEIVE AND TRANSMIT
4-12
Previous view
When using your RTTY terminal or TNC, consult the
manual that comes with the equipment.
Select the desired frequency band. (p. 35)
q
On the Mode selection screen, touch “RTTY” to se-
w
lect the RTTY mode.
•
After the RTTY mode is selected, touch “RTTY” again to
toggle between the normal and reverse modes, if need-
ed.
Enter the RTTY decoder screen.
e
q
Push
MENU
(
C
) one or more times to select the
“M-2” screen (M-2 menu).
w
Touch [DEC](
D
) to display the RTTY decoder
screen.
•
Touch [WIDE](
D
) to toggle the decode screen size
between normal and wide.
Rotate the Dial to tune a desired signal.
r
• The S-meter displays the received signal strength.
•
If the received signal cannot be demodulated, try to se-
lect the RTTY reverse mode in step
w
.
•
The tuning step can be changed on the Tuning step se-
lection screen by touching “kHz frequency.” (p. 38)
Switch ON the external TX switch to set the trans-
t
ceiver to the transmit mode, or transmit a SEND sig-
nal from your TNC.
• The TX/RX indicator lights red.
•
The Po meter displays the transmitted RTTY signal
strength.
Use your connected PC or TNC (TU) to transmit
y
RTTY (FSK) signals.
Switch OFF the external TX switch to receive.
u
Convenient Receive functions
• Preamp and attenuator (p. 71)
• Twin PBT (passband tuning) (p. 75)
• AGC (auto gain control) (p. 72)
• Noise blanker (p. 76)
• Noise reduction (p. 77)
• Notch fi lter (p. 77)
• ¼ function (p. 39)
• Twin Peak Filter (p. 58)
Operating RTTY (FSK)
The
L
,
R
,
C
or
D
in the
instructions indicate the
part of the controller.
L
: Left side
R
: Right side
C
: Center bottom
D
: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay
“RTTY” or “RTTY-R” appears
Touch [DEC]
Rotate the Dial to the point where both
sides of the dots equally appear.