![background image](http://html2.mh-extra.com/html/icom/ic-7100/ic-7100_instruction-manual_3605333135.webp)
13
USING AN SD CARD
13-15
Previous view
Cloning Transceiver-to-Transceiver using an SD card
This topic describes the cloning method using the SD
card.
Memory channel contents, Set mode item settings and
repeater list can be saved onto a SD card.
Recorded voice memories are not included in the clon-
ing data. To play back the master transceiver’s voice
memory, insert the SD card into sub transceiver, or
make a copy onto the sub transceiver’s SD card using
a PC.
Description is with the SD card is already inserted.
Saving the master transceiver’s setting data onto
1.
the SD card.
q
Save the master transceiver’s setting data onto the
SD card, as described on page ??.
Remove the SD card from the master transceiver,
2.
and then insert it to the sub transceiver.
w
Turn OFF the master transceiver’s power.
e
Remove the SD card from the master transceiver as
shown at right.
r
Insert the removed SD card into the sub transceiver,
then turn ON the sub transceiver’s power.
Loads the setting data into the sub transceiver.
3.
t
The master transceiver’s setting data loads into the
sub transceiver, as described on page ??.
The
L
,
R
,
C
or
D
in the
instructions indicate the
part of the controller.
L
: Left side
R
: Right side
C
: Center bottom
D
: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay
SD card
Master transceiver
Sub transceiver
Push
Pull out
Front
panel
When you load the data, be sure to set the loading
content as “Repeater List Only” or “Select” in the LOAD
FILE screen, and if “Select” is selected, the “REF Ad-
just” check box must be cleared.
Otherwise, it may result in a frequency deviation.
or
LOAD FILE screen
Touch “Repeater List Only”
LOAD OPTIOIN screen
( Appears when “Select”
is touched in the LOAD
FILE screen)
Touch “Load” without check-
ing the “REF Adjust” box.