15
VOICE TX FUNCTION
15-6
Previous view
Push
q
MENU
(
C
) one or more times to select the “M-
2” (Menu 2) screen.
•
In the DR mode, select the “D1” screen.
Touch [VOICE](
w
D
) to select the Voice TX mode.
•
“VOICE TX” screen is displayed.
Push
e
MENU
(
C
) to display the “VOICE” screen.
r
<<Single TX>>
Touch the desired memory, [T1] through [T4] to
transmit the recorded voice audio once.
<<Repeat
TX>>
Touch the desired memory, [T1] through [T4] for 1
second to repeatedly transmit the recorded voice
audio for up to 10 minutes at the interval specified in
“Repeat Time.”
•
Even if 10 minutes pass while transmitting, the voice au-
dio is completely transmitted.
•
During the Voice TX waiting, the selected memory
blinks.
•
One of the following steps will cancel the transmission.
- Touch the memory again.
- Turn OFF the power, then turn it ON again.
- Touch another memory (except for [LEVEL]).
- Push
MENU
(
C
),
XFC
(
R
) or
SET
(
C
).
- Push
QUICK
(
C
).
The repeat transmission is cancelled. But while trans-
mitting, the voice audio is completely transmitted.
•
Once the Repeat TX is made, the transceiver pauses
until the end of the “Repeat Time,” then transmits again.
After the second transmission, the Repeat TX continues
pausing, if receiving a signal.
But if the squelch is manually opened, the voice audio is
repeatedly transmitted, according to the repeat time set-
ting.
•
Voice TX Waiting screen for <<Repeat TX>>
Transmitting the recorded voice audio
Blinks while
transmitting
Touch
[VOICE]
Touch the
desired
memory,
Single TX
Repeat TX
Blinks
The
L
,
R
,
C
or
D
in the
instructions indicate the
part of the controller.
L
: Left side
R
: Right side
C
: Center bottom
D
: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay