REFERENCE INFORMATION
14
75
14-5 Practical Setting Example
This section presents some of the setting values
entered when the AP-3 unit is used in the network
configuration illustrated below.
For setting items not shown here, enter values that
are appropriate for the particular network configura-
tion.
[DR-1 WL:
Required Settings]
• Use DHCP server func-
tion.
• DR-1WL IP address:
192.168.0.1
• Use RIP on the LAN
side.
• Use substitute response
function of DNS server.
Internet
Wireless terminal
Wired terminal
SL-1100
SL-1100
AP-3
DR-1WL
■
Using the different subnets for the wired LAN and the wireless LAN
[AP-3:
Required Settings]
• Use DHCP server func-
tion.
• AP-3 IP address:
192.168.0.2
• Initial allocation IP
address: 192.168.0.50
• Use RIP.
• Use routing mode.
[Setting Tips]
Change the values in both
the "Wired LAN" and
"Wireless LAN" columns of
the [DHCP Server Settings]
screen.
Set the initial allocation IP
address so that the range of
IP addresses over which the
AP-3 can allocate does not
overlap the range of IP
addresses over which the
DR-1WL (router) can allo-
cate.
Set the [Default Gateway] to
the same value as the IP
address of the AP-3 unit.
Set the [Primary DNS
Server] to the same value as
the IP address of the DR-
1WL.
[AP-3 Network Settings] screen
[Routing Setting] screen
* The wired terminal will obtain an IP address from either
the DR-1WL or the AP-3.
* The wireless terminal will obtain an IP address from the
AP-3.
* The routing information created using RIP is displayed
on the [IP Routing Information] screen.
