IBM xSeries 300, Service Manual

Page: 105 / 160

v
Insert the Restore 0 diskette in the diskette drive A.
v
Select Reboot, then press Enter.
v
The following screen appears.
IBM
IBM Nways Switch Control Program
NAS Disk Restore
(c) Copyright IBM Corp. 1987, 1997. All rights reserved
Remove the diskette from drive A.
Insert the NAS Restore Diskette 1 into the Drive A
Then, Press Enter
v
Insert the Restore 1 diskette, then press Enter. Continue with Step 005.
005
– You have changed the first hard disk; continue, using the following procedure.
v
The boot of the diskette takes several minutes. Successively the IBM logo, the
WARP logo, and the following messages appear on the screen:
Do you really want to restore the primary disk on a xxxxx MB drive (Y/N)?
Note: xxxxx specify the disk size.
v
Type Y, then press the Enter key.
Do you want to stop the restore operation (Y/N)?
v
Type N then press the Enter key.
This is your last chance...
If you reply "Y" the primary disk will be restored.
Are you sure you want to continue restore (Y/N)?
v
Type Y then press the Enter key.
v
Disk partitioning is started and the following messages appear:
Creating --> Partition at location xxxx size yyy
Creating --> Partition at location xxxx size yyy
Creating --> Partition at location xxxx size yyy
-------- -----------------------------------
v
At the end of the operation, the following message appears:
Restart system to maintain configuration integrity.
The new MBR has successfully been written.
First Disk preparation (FDISK) complete.
Remove the diskette from the drive.
Restore will continue from the second disk.
Press any key to continue.
v
Remove the Restore diskette and press any key.
MAP 0520 (continued)
Chapter 5. Nways Switch Administration Station FRU and Display Exchange Procedures
5-23