IBM x3800 - System - 8865, Manual

Page: 51 / 196

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, System x3800 Type 8865,” on page 107 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error message Action
POST reporting memory event: DIMM Disabled -
Failed POST/BIOS Memory Test. Chassis
Number = X. Memory Card = Y. Memory DIMM
= Z.
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
POST reporting memory event: DIMM Disabled -
Failed ECC Test. Chassis Number = X. Memory
Card = Y. Memory DIMM = Z.
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
POST reporting memory event: DIMM Disabled -
Failed ECC Test. Chassis Number = X. Memory
Card = Y. Memory DIMM = Z.
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
Unknown SERR/PERR detected on PCI bus
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
Address of special cycle DPE on PCI primary
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
Master read parity error on PCI primary
Chassis#=4 Slot#=2 Bus#=3 Dev.ID=0xaa99
Vend.ID=0xccbb Status=0xeedd DevFun#=0xff
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
Received target parity error on PCI primary
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
Chapter 2. Diagnostics
35