IBM x3800 - System - 8865, Manual

Page: 148 / 196

Replacing the operator information panel assembly
To install the replacement operator information panel assembly, complete the
following steps.
TO
W
ER
Tabs
Retention tab
RA
CK
1. Press the ferrite core into place.
2. Connect the light path diagnostics ribbon cable and front USB cable to the I/O
board.
3. Slide the front of the operator information panel assembly into the opening in
the chassis.
4. Insert the tabs into the guide slots on the operator information panel assembly;
then, push the assembly toward the front of the server until it stops.
Note: To install the operator information panel assembly in the tower position
the tabs must be inserted into the middle and rear guide slots. To install the
operator information panel assembly in the rack position the tabs must inserted
into the front and middle guide slots. When the assembly is in position, “RACK”
or “TOWER” will be visible through the opening at the rear of the assembly.
5. Connect the light path diagnostics ribbon cable and front USB cable to the I/O
board.
6. Install the top cover, front cover (tower model only), and bezel (see “Replacing
the top cover, bezel, and front cover” on page 121).
7. Connect the cables and power cords (see “Connecting the cables” on page 118
for cabling instructions).
8. Turn on all attached devices and the server.
132
IBM System x3800 Type 8865: Problem Determination and Service Guide