IBM x3800 - System - 8865, Manual

Page: 151 / 196

Replacing the support structure
To install the replacement support structure, complete the following steps.
Latches
Alignment tabs
Alignment pins
Cable retention
clip
Attention: Do not allow any cables to be pinched or caught on metal protrusions.
1. Align the tabs on the support structure with the notches on the rear of the
chassis; then, gently lower the structure into the server and guide the cables
through the slot in the bottom of the structure. Make sure that the structure is
firmly seated in the chassis.
2. Push the two blue latches of the support structure toward the rear of the server
until they lock the structure into position.
3. Connect the signal cables to the I/O board and close the retention latch.
4. Replace the memory cards.
5. Install the top cover (tower model only) and lock the front cover (see “Replacing
the top cover, bezel, and front cover” on page 121).
6. Connect the cables and power cords (see “Connecting the cables” on page 118
for cabling instructions).
7. Turn on all attached devices and the server.
Removing and replacing Tier 2 CRUs
You may install a Tier 2 CRU yourself or request IBM to install it, at no additional
charge, under the type of warranty service that is designated for your server.
The illustrations in this document might differ slightly from your hardware.
Removing the battery
The following notes describe information that you must consider when replacing the
battery in the server.
v
When replacing the battery, you must replace it with a lithium battery of the same
type from the same manufacturer.
v To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
Chapter 4. Removing and replacing server components
135