IBM x3800 - System - 8865, Manual

Page: 149 / 196

Removing the IBM Remote Supervisor Adapter II SlimLine
The Remote Supervisor Adapter II SlimLine must be installed in its dedicated
connector on the I/O board.
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps.
I/O board
Remote Supervisor Adapter II SlimLine
Remote Supervisor Adapter II SlimLine connector
Rear standoff
Front standoff
Retention latch
Retention latch
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 115.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Unlock the front cover (tower model only) and remove the top cover (see
“Removing the top cover, bezel, and front cover” on page 119).
4. Note the location of the cables connected to the I/O board; then, remove the
cables from the I/O board.
5. Remove the I/O board (see “Removing the I/O board” on page 139) and place
the board on a static-protective surface with the battery facing up.
6. Release the retention latch on the rear standoff and pull the adapter from the
I/O board.
7. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing the IBM Remote Supervisor Adapter II SlimLine
To install the replacement Remote Supervisor Adapter II SlimLine, complete the
following steps:
1. Insert the rear of the adapter into the rear standoff; then, rotate the front of the
adapter into the front standoff.
2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
3. Install the I/O board (see “Replacing the I/O board” on page 140).
4. Install the top cover and lock the front cover (tower model only) (see “Replacing
the top cover, bezel, and front cover” on page 121).
Chapter 4. Removing and replacing server components
133