IBM TotalStorage NAS 300, User Reference

Page: 54 / 200

6. After you enter the data, click Continue .
7. Verify the information. If it is correct, click Yes to start the configuration.
Configuration takes a few minutes.
8. If you are prompted to select a user account, enter the user name and
password for the domain account that you want the cluster service to use.
9. If you are prompted to select a disk on which to store cluster checkpoint and
log files, do the following:
a. Select the disk on which the Quorum is located (for instance, G , if this is
what you specified earlier) and click Next .
b. Click Finish at the Cluster Information panel.
10. Cluster configuration completes for the first node.
11. Power on the joining node. (You will join this node to the cluster.)
12. In the Cluster Setup wizard, click Joining Node .
13. In the First Node Information panel, enter the name of the first node.
14. At the prompt, specify the domain.
15. If prompted to confirm the Administrator name and password, enter that
information and click Finish .
You will see a message that configuration takes a few minutes. When configuration
completes, the Cluster Administration function starts.
Go to “Verifying network connectivity and names resolution” on page 35 and
complete the procedure to verify network connectivity and names resolution.
You have now completed cluster setup.
Figure 4. Cluster Information panel
40
NAS Gateway 300 User’s Reference