IBM Storwize V7000, Problem Determination Manual

Page: 133 / 314

8. While you slightly press the top of the metal clip, rotate the metal clip toward
the front of the server until the metal clip clicks into place. Make sure the
metal clip is securely engaged on the chassis.
Attention: Pressing the top of the metal clip with excessive force may cause
damage to the metal clip.
9. Touch the static-protective package that contains the new Ethernet adapter to
any unpainted metal surface on the server. Then, remove the Ethernet adapter
from the package.
10. Align the adapter with the adapter connector on the system board; then, tilt
the adapter so that the port connectors on the adapter line up with the port
openings on the chassis. See Figure 16.
11. Slide the port connectors on the adapter into the port openings on the chassis;
then, press the adapter firmly until the two standoffs engage the adapter.
Make sure the adapter is securely seated on the connector on the system
board.
Make sure the port connectors on the adapter do not set on the rubber
stopper. The following illustration shows the side view of the adapter in the
1
3
2
1
2
sonas200
Figure 15. Location of the port openings on the chassis
Standoff
Ethernet
adapter connector
1
2
sonas202
Figure 16. Aligning the Ethernet adapter port connectors with the port openings
Chapter 4. File module
109