IBM Storwize V5000 Gen 2 Series, Quick Installation Manual

Page: 152 / 178

Figure 136. Mini SAS HD to Mini SAS HD cable
• Mini SAS HD to Mini SAS (Figure 137 on page 126)
Figure 137. Mini SAS HD to Mini SAS cable
Note: When you insert a SAS cable, make sure that the connector is oriented correctly.
• When you connect cables to the SAS ports on the left side of the node canister, the blue pull tab must
be below the connector.
• When you connect a cable to a SAS 4-port host interface adapter, the blue pull tab must be above the
connector.
• Insert the connector gently until it clicks into place. If you feel resistance, the connector is probably
oriented the wrong way. Do not force it.
• When inserted correctly, the connector can only be removed by pulling the tab.
Procedure
To install the cables, complete the following steps.
1. Connect the required number of SAS cables.
Refer to the "Planning" section of the IBM Knowledge Center for instructions on determining the
number of cables required.
Note: When you connect cables to the SAS ports on the left side of the node canister, each host must
be connected to both canisters. Both canisters must have the same number of cables connected.
2. Arrange the cables to provide access to the hardware.
• USB ports. USB port access is required when you use a USB flash drive to configure the system.
• The enclosures themselves. Access is required to the hardware for servicing and for safely
removing and replacing components by using two or more people.
126 Storwize V5000 Gen2: Quick Installation Guide