IBM RS6000 - 7026 - H70, Service Manual

Page: 80 / 358

Table 3-1 (Page 7 of 24). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
25A80xxx NVRAM problems NVRAM problem resolution:
1. Errors reported against NVRAM
can be caused by low Battery
voltage and (more rarely) power
outages that occur during normal
system usage. With the exception
of the 25A80000 error, these errors
are warnings that the NVRAM data
content had to be re-established
and do not require any FRU
replacement unless the error is
persistent. When one of these
errors occurs, any system
customization (eg. boot device list)
information has been lost, the
system may need to be
re-configured.
2. If the error is persistent, replace
the battery.
3. If the error is persistent after
battery replacement, or the error
code is 25A80000, replace the I/O
board. (See notes on 3-1.)
25A80000 Initialization failed, device test failed. Refer to Action under error code
25A80xxx.
25A80001 Init-nvram invoked, ALL of NVRAM
initialized. Refer to Action under error code
25A80xxx.
25A80002 Init-nvram invoked, some data
partitions may have been preserved. Refer to Action under error code
25A80xxx.
25A80011 Data corruption detected, ALL of
NVRAM initialized. Refer to Action under error code
25A80xxx.
25A80012 Data corruption detected, some data
partitions may have been preserved. Refer to Action under error code
25A80xxx.
25A80100 NVRAM data validation check failed. Turn off, turn on system unit and retry
the operation before replacing any
system component. Refer to Action
under error code 25A80xxx.
25A80201 Unable to expand target partition while
saving configuration variable. Refer to Action under error code
25A80xxx.
25A80202 Unable to expand target partition while
writing error log entry. Refer to Action under error code
25A80xxx.
25A80203 Unable to expand target partition while
writing VPD data. Refer to Action under error code
25A80xxx.
3-8
Service Guide