IBM RS6000 - 7026 - H70, Service Manual

Page: 154 / 358

2. Select the pdisk that you want to certify. The following instructions are
displayed:
┌──────────────────────────────────────────────────────────────────────────────────┐
│ SSA SERVICE AIDS
8ð238ð │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ CERTIFY DISK
8ð24ð4 │
┌──────────────────────────────────────────────────────────────────────────────────┐
│ CERTIFY DISK
8ð24ð5 │
│ │
│ pdisk1 22222222 ðð-ð4-P 2 GB SSA F Physical Disk Drive │
│ │
│ Move cursor onto selection, then press Enter. │
│ │
│ Set or Reset Identify. │
│ Select this option to set or reset the Identify indicator │
│ on the disk drive. │
│ Certify. │
│ Select this option to start the Certify operation. │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ F3=Cancel F1ð=Exit │
│ │
└──────────────────────────────────────────────────────────────────────────────────┘
3. If you are not sure of the identification (pdisk number) of the disk drive module
that you want to format, use the identify function to get a positive physical
identification of the module (see “The Identify Function” on page 3-65). You can
further ensure that you have selected the correct disk drive module by verifying
that the serial number on the front of the disk drive module is the same as the
serial number that is displayed on the screen.
4. When you are sure that you have selected the correct disk drive module, select
Certify
3-82
Service Guide