IBM RS6000 - 7026 - H70, Service Manual

Page: 59 / 358

Step 1540-10
The system is working correctly with this configuration. One of the FRUs (adapters)
that you removed is probably defective,
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn the power off and remove the power cable.
3. Install the second CPU card if one was removed. If a second CPU card was not
removed, or has already been reinstalled and verified, install an I/O Planar
device (parallel port device, serial port device, keyboard or mouse) that had been
removed and any cables that were attached. If all I/O Planar devices have been
reinstalled and verified, install a FRU (adapter) and connect any cables and
devices that were attached to it.
Note: If the FRU you installed requires supplemental media use the Process
Supplemental Media task to load the supplemental media first.
4. Reinstall the power cable.
5. Turn the power on.
6. If the Console Selection screen displays, choose the system console.
7. After the keyboard indicator displayeds, press the F5 key on the directly-attached
keyboard or the number 5 key on an ASCII terminal keyboard.
8. Enter the appropriate password when prompted to do so.
Is the "Please define the System Console" screen displayed?
NO Go to “Step 1540-11” on page 2-30.
YES Repeat this step until all of the FRUs (adapters) are installed, then go to
"MAP 410: Repair Checkout" in the
IBM RS/6000 Diagnostic Information
for Multiple Bus Systems.
Chapter 2. Maintenance Analysis Procedures
2-29