IBM RS6000 - 7026 - H70, Service Manual

Page: 327 / 358

Modem Configuration Samples
Sample File modem_z.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP Z
#
# FUNCTIONS: Modem configuration file for many early Hayes\ compatible modems.
#
This example uses the ATZ reset command to choose the factory defaults.
# This setup will work for many modems, but it is required for early vintage
# modems which respond to neither the ATZð reset command nor the extended (&)
# commands. Refer to your modem manual.
#
# \ Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials - Property of IBM
#
# US Government Users Restricted Rights - Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.
ICDelay 1
DefaultTO 1ð
CallDelay 12ð
# AT Attention Code , Inserts delay in dialing commands
# Z Reset to factory defaults Qð Turn on responses
# Eð Turn echo off Q1 Turn off responses
# Vð Use numeric responses Sð=ð Automatic answer inhibit
# +++ Escape to command mode Sð=2 Answer on second ring
# Hð Hang-up T = Tone mode. When used as T\r, it is a
# no op to maintain program synchronization
# when modem may/will echo the commands.
#
# %N Call-Out phone number %P Paging phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 1ð, 5 and 1 are connection responses.
Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; ð=OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (").
condout: send "ATZQðT\r" # Reset to factory defaults.
ignore "ð\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATEðT\r" # Initialize modem: Echo OFF,
expect "ð\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQðVðT\r" # Limit response codes.
expect "ð\r" timeout 2 # Confirm commands successful.
send "ATSð=ð\r" # Set AutoAnswer OFF
expect "ð\r" timeout 2 # Confirm command successful.
done
connect: send "ATDT%N\r" # Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1ð\r" or "5\r" or "1\r" busy "7\r"
timeout 6ð
done
Appendix D. Modem Configurations
D-9