IBM RS/6000 7043 260, Service Manual

Page: 305 / 322

timeout 6ð
done
retry: send "A/" # Repeat the previous command.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1ð\r" or "5\r" or "1\r" busy "7\r"
timeout 6ð
done
disconnect:
delay 2 # Separate from previous data.
send "+++" # Assure command mode.
delay 2 # Allow mode switching delay.
send "ATHðT\r" # Set modem switch-hook down
#
(i.e., hang up).
ignore "ð\r" or "OK\r" timeout 2 # Ignore modem response.
send "ATEðQ1\r" # Initialize modem: Echo OFF,
# Disable responses.
ignore "ð\r" timeout 1
done
condin: send "AT&F1QðT\r" # Reset modem. Select profile 1
ignore "ð\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATEðT\r" # Initialize modem: Echo OFF,
expect "ð\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQðVðXðT\r" # Limit response codes.
expect "ð\r" timeout 2 # Confirm commands successful.
send "ATSð=2\r" # Set AutoAnswer ON
expect "ð\r" timeout 2 # Confirm command successful.
send "AT&C1&D2&R1\r" # Detect carrier and DTR,
# Ignore RTS.
expect "ð\r" timeout 2 # Confirm command successful.
done
waitcall: ignore "2\r" timeout 1 # Ignore first ring.
expect "2\r" timeout 1ð # Pick up second ring
# or timeout.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1ð\r" or "5\r" or "1\r"
timeout 6ð
done
page: send "ATDT%N,,,,%R;\r" # %N = pager call center number
# Add enough commas to wait for
#
time to enter paging number.
# %R = paging number
# Confirm successful command.
expect "ð\r" timeout 6ð
delay 2
# Wait before hanging up.
send "ATHðT\r" # Hang up.
expect "ð\r" timeout 2 # Confirm successful command.
done
ripo: send "AT&F1QðT\r" # Reset modem. Select profile 1
ignore "ð\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATEðT\r" # Initialize modem: Echo OFF,
expect "ð\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQðVðXðT\r" # Limit response codes.
expect "ð\r" timeout 2 # Confirm commands successful.
send "ATSð=ð\r" # Set AutoAnswer OFF
expect "ð\r" timeout 2 # Confirm command successful.
send "AT&C1&D2&R1\r" # Detect carrier and DTR,
# Ignore RTS.
expect "ð\r" timeout 2 # Confirm command successful.
done # RI Power On enabled.
Appendix A. Service Processor Information
A-61