Procedure
1.
If you are not already grounded, properly ground yourself.
2.
Open the CPU air duct, if necessary, and locate the DIMMs on the controller
module. The NVMEM DIMMs are located in DIMM slots 1 and 2, and have
white DIMM locking tabs. There is also a fault LED for these DIMMs.
This illustration shows a system fully populated with DIMMs:
1
NVMEM DIMMs 1 and 2.
2
System DIMMs 1 through 4.
The number of DIMMs in your system will vary. DIMM sockets 1 and 2 are always
populated in all N6200 series models, while DIMM sockets 3 and 4 are only
populated in the N6270.
3
DIMM sockets.
The NVMEM DIMM sockets have white DIMM locking tabs, while the system
DIMM sockets have black locking tabs.
3.
Note the orientation of the DIMM in the socket so that you can insert the
replacement DIMM in the proper orientation.
1 2
1 2 3 4
1
2
3
Figure 20. DIMM locations
36
IBM System Storage: N6200 Series Hardware and Service Guide
Summary of Contents for N6270
