IBM INTELLISTATION E PRO 6204, User Manual

Page: 78 / 162

62
IBM® IntelliStation® E Pro: User’s Guide
Installing an adapter: Do the following to install an adapter in the tower model:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 37.
1. Review the information in “Safety information” on page vii.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords; then remove the side cover. See
“Removing the side cover” on page 58.
4. Determine which PCI slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route any cables
before you install the adapter.
5. For full-length adapters, rotate the rear adapter-retention bracket to the open
(unlocked) position and remove it from the computer. Rotate the front adapter-
retention bracket to the open position. If you are installing a smaller adapter,
remove only the rear adapter-retention bracket.
6. Remove the expansion-slot cover. From the rear of the computer, press on the
slot cover. Grasp it and pull it out of the expansion slot. Store it in a safe place for
future use.
Attention: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the computer and ensures proper
ventilation of computer components.
7. Set any jumpers or switches on the adapter or system board as described by the
adapter manufacturer.