IBM INTELLISTATION E PRO 6204, User Manual

Page: 106 / 162

90
IBM® IntelliStation® E Pro: User’s Guide
184 Asset Control Antenna
not Detected No antenna detected with
AssetCare enabled. Auto-configure and
request (accept User
password if no
Administrator password
set).
186 Security Hardware
Control Logic Error Refer to “Security” on
page 29. Refer to “Security” on
page 29.
190 System security: Invalid
Remote Change
Requested
191 System security: IBM
Embedded Security
Hardware Reset.
193 System security: IBM
Embedded Security
Hardware Removed
195 System security: Asset
ID Antenna has been
installed AssetID antenna added. Refer to AssetID antenna
configuration matrix.
196 System Tampered
Cleared Refer to “Security” on
page 29. Refer to “Security” on
page 29.
201 Memory Error Failure in Enhanced
POST memory test, or
the SPD indicates an
installed DIMM is not
supported. If your computer does not
have the latest level BIOS
code installed, update
the BIOS code to the
latest level.
Ensure that the DIMM is
properly seated.
1. Reseat the failing
DIMM.
2. If the problem
remains, replace the
DIMM.
If the problem persists,
call for service.
210 Stuck key When in POST, a stuck
key has been detected. Correct the stuck key.
211 Keyboard error No keyboard has been
detected. 1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace the
keyboard cable.
If the problem persists,
call for service.
250 System battery is dead
Replace and run SETUP Bit 7 or RTC Status
Register D is set,
indicating the RTP lost
power. Replace the battery. See
“Replacing the battery” on
page 110.
Table 11. Diagnostic error messages.
Code Text message Detection Action