IBM INTELLISTATION E PRO 6204, User Manual

Page: 63 / 162

Chapter 5. Installing options
47
Notes:
1. The IntelliStation E Pro computer supports only one diskette drive.
2. The IntelliStation E Pro Type 6204 does not support the installation of additional
internal disk drives. However, you can replace failed internal drives.
3. For a complete list of supported options for your computer, refer to
http://www.ibm.com/pc/support/ on the World Wide Web.
Preinstallation steps : Before you replace drives in your computer, verify that you
have all the cables and other equipment specified in the documentation that comes
with the drive. You might also need to perform certain preinstallation activities. Some
steps are required only during the initial installation of an option.
1. Read “Safety information” on page vii, “Handling static-sensitive devices” on page
37, and the documentation that comes with your drive.
2. Choose the bay in which you want to install the drive.
3. Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, be sure to
set the SCSI ID for that device.
Installing a CD-ROM or diskette drive: To replace drives in the desktop model
computer, do the following:
1. Read the information in “Preinstallation steps”.
2. Turn off the computer and attached devices, and disconnect all external cables
and power cords.
3. Remove the cover. See “Removing the cover” on page 41 for details.
4. Disconnect power and signal cables to the drive.
5. Rotate the drive bay cage of the drive that you need to replace until the latch
catches the front of the computer chassis.
6. Remove the screws holding the drive in place.
7. Slide the drive out of the drive bay.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
8. Touch the static-protective bag containing the drive to any unpainted metal
surface on the computer; then remove the drive from the bag and place it on a
static-protective surface.
9. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
DANGER
Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.