IBM INTELLISTATION E PRO 6204, User Manual

Page: 65 / 162

Chapter 5. Installing options
49
5. Remove the hard disk drive cage from the computer.
6. Slide the drive out of the drive bay.
7. Touch the static-protective bag containing the drive to any unpainted metal
surface on the computer; then remove the drive from the bag and place it on a
static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
9. Attach the sliding rails to the sides of the hard disk drive using screws from the old
hard disk drive.
10. Slide the drive into the drive bay until the drive snaps into place, and replace the
drive cage.
11. Connect one end of the IDE signal cable into the back of the drive and the other
end of the cable into the IDE connector on the system board. For the location of
the IDE connectors, see “System board internal cable connectors” on page 40.
Note: Make sure to route the signal cable so that it does not block the air flow to
the rear of the drives or over the microprocessor.
12. Connect a power cable to the back of the drive. The connectors are keyed and
can be inserted only one way.