IBM DS3500, Installation, User'S, And Maintenance Manual

Page: 130 / 193

a.
Press the latch on the end of the tray handle to release it, then pull out the tray handle to the open
position.
b.
Pull the drive approximately 12 mm (0.5 in.) out of the bay and wait 70 seconds to allow the drive
to spin down and the storage subsystem controller to recognize that a drive is removed from the
configuration.
4.
(DS3524 and EXP3524) Remove the drive.
DANGER
Electrical voltage and current from power cables are hazardous. To avoid a shock hazard, always
place electrical equipment on dry, static-free level surfaces. Never turn on any electrical
equipment when there is evidence of fire, water, or structural damage.
a. Push up the latch on the handle, then open the drive handle and pull the drive assembly out of
the server.
Drive tray
Tray handle
Latch
Hard disk drive
Figure 5-11. Removing a drive from a DS3512 or EXP3512
Sy stem
Sto
rage
Hard disk
drive status
LED (amber)
Hard disk
drive
assembly
Drive
handle
Release
latch
Hard disk
drive activity
LED (green)
Figure 5-12. Removing a drive from a DS3524 or EXP3524
5-14
System Storage DS3500 and EXP3500: Installation, User's, and Maintenance Guide