IBM 86803RU - Netfinity 7000 M10, Hardware Maintenance Manual

Page: 69 / 278

Dialout Entry Information Group:
To edit or create
a Dialout Entry:
1. In the Name field, type the name of the person or
system to which the alert will be forwarded. The
information in the Name field is strictly for your use in
identifying the Dialout Entry. If you are editing a
previously configured Dialout Entry, select the entry
that you want to edit from the Name selection list.
2. In the Number field, type the telephone number that
will be used by the system's modem to dial out to a
digital pager service. After the modem connects to
the pager service, it will send numeric data specific to
the dialout event.
Note
Depending on your paging service, you might
need to increase the amount of time that this
alert action waits after dialing the telephone
number before it transmits the numeric data. To
increase the amount of time that will pass before
the numeric data is transmitted, add one or more
commas (,) to the end of the telephone number.
Each comma will cause the modem to wait two
seconds before transmitting the numeric data.
3. In the PIN field, type the personal identification
number required by your alphanumeric pager
provider. This field will be active only if you select
Alpha-numeric in the Type field.
4. From the Type selection list, select the type of
connection the system management subsystem will
attempt to make in order to forward the event
notification. You can select Numeric (for standard
pagers), Alpha-numeric (for alphanumeric pagers), or
Netfinity (for connecting to a remote Netfinity system).
5. Check the Entry enabled check box to activate this
Dialout Entry. If the Entry enabled check box is not
checked, no dialouts will be made to this entry.
6. Select dialout events from the Enabled Alerts
Dialout group. If any of the checked events occur,
the system management subsystem will dial out to
the telephone number specified in the Number field
and forward an alert describing the event using the
method selected in the Type field. For more detailed
information about dialout events, see “Enabled Alerts
Dialout Group” on page 62.
7. Click on Apply/Add to save these settings.
To remove a previously configured Dialout Entry, select the
name of the entry from the Name selection list and then
select Delete.
Netfinity 7000-M10 - Type 8680
61