IBM 86803RU - Netfinity 7000 M10, Hardware Maintenance Manual

Page: 160 / 278

b. Insert the DIMM into the connector by pressing
on one edge of the DIMM and then on the other
edge of the DIMM. Be sure to press straight into
the connector.
c. Repeat the preceding step to make sure the
DIMM is seated correctly.
d. Make sure the retaining clips
.2/
are in the
closed position.
e. If a gap exists between the DIMM and the
retaining clips, the DIMM has not been properly
installed. In this case, open the retaining clips
and remove the DIMM; then, reinsert the DIMM.
f. Repeat these steps for each memory module
that you install.
5. Reinstall the memory board:
a. Insert the memory board into the guides and
gently press the memory board into the socket.
Attention
When you install the memory board in the
server, be sure that it is completely and
correctly seated in the connector before you
apply force to close the latches. Incomplete
insertion might cause damage to server
components.
b. Push the latches
.1/
until they close and lock in
place.
6. If you have other options to install or remove, do so
now; otherwise, go to “Completing the Installation” on
page 97.
152
Netfinity Server HMM