IBM 86803RU - Netfinity 7000 M10, Hardware Maintenance Manual

Page: 149 / 278

To replace a drive in a hot-swap bay:
Refer to the illustration in “Installing a Drive in a Hot-Swap
Bay” on page 138 while you perform the steps in this
procedure.
1. Remove the defective hard disk drive
.2/
by pressing
on the lock to release the handle
.3/
, placing the
handle in the open position (perpendicular to the
drive), and pulling the hot-swap tray from the bay.
2. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (that is,
perpendicular to the drive).
b. Align the drive/tray assembly so that it engages
the guide rails in the bay.
c. Push the drive assembly into the bay until the
drive connects to the backplane.
d. Push the tray handle to the right until it locks.
3. Check the hard disk drive status indicators to verify
that the hard disk drives are operating properly. See
“Identifying Problems through Status Indicators” on
page 16 for details.
Netfinity 7000-M10 - Type 8680
141