IBM 86803RU - Netfinity 7000 M10, Hardware Maintenance Manual

Page: 163 / 278

d. Remove the bracket from the server.
4. Determine the microprocessor socket in which you
want to install the new microprocessor.
Note
Your server comes with a microprocessor
installed in socket 1. Install a second
microprocessor in socket 2, a third
microprocessor in socket 3, and a fourth
microprocessor in socket 4.
5. If you are adding a fourth microprocessor, remove the
microprocessor terminator card
.8/
:
Note
To maintain signal quality and system reliability, a
microprocessor or the microprocessor terminator
card must be installed in microprocessor socket
4.
a. Pull the microprocessor terminator card latches
so they rotate to a 90-degree angle from the
microprocessor terminator card.
b. Grasp the two latches and carefully pull the
microprocessor terminator card from the server.
c. Store the microprocessor terminator card in a
safe place.
6. Install the two voltage regulator modules (VRM)
.6/
included in the microprocessor kit.
a. Refer to the label in front of the processor board
inside the server for the location of the VRM
sockets.
Note
Install the VRMs for a second
microprocessor in VRM sockets 2a and 2b.
Install the VRMs for a third microprocessor
in VRM sockets 3a and 3b. Install the
VRMs for a fourth microprocessor in VRM
sockets 4a and 4b.
b. Lift on the VRM retention bracket
.5/
to detach
the bracket from the chassis.
c. Carefully remove the bracket from the server.
d. Install the VRMs in the VRM sockets.
e. Install the VRM retention bracket.
Note
When correctly installed, the bracket holds
the VRMs securely in place and does not
move or shift.
7. Install the microprocessor:
a. Touch the static-protective package containing
the new microprocessor to any
unpainted metal
Netfinity 7000-M10 - Type 8680
155