IBM 86803RU - Netfinity 7000 M10, Hardware Maintenance Manual

Page: 164 / 278

surface on the server; then, remove the
microprocessor from the package.
b. Insert the microprocessor into the guides
.7/
and gently press the microprocessor into the
socket. When correctly inserted, the
microprocessor heat sink faces to the left.
Attention
Make sure the microprocessor is oriented
and aligned correctly before you try to press
it into the socket.
c. Push the latches
.3/
until they close and lock in
place.
8. Install the microprocessor retention bracket:
a. Insert the bottom edge of the bracket in the
matching openings in the guide support.
b. Rotate the bracket over the microprocessors.
c. Grasp the bracket handle and press the bracket
firmly into place. Insert both tabs on the bracket
in the matching openings on the server chassis.
Note
When correctly installed, the bracket holds
the microprocessors securely in place and
does not move or shift.
9. Install the memory board:
a. Insert the memory board into the guides and
gently press the memory board into the socket.
Attention
When you install the memory board in the
server, be sure that it is completely and
correctly seated in the connector before you
apply force to close the latches. Incomplete
insertion might cause damage to server
components.
b. Push the memory board latches
.1/
until they
close and lock in place.
10. If you have other options to install or remove, do so
now; otherwise, go to “Completing the Installation” on
page 97.
156
Netfinity Server HMM