IBM 7378, Problem Determination And Service Manual

Page: 321 / 362

When you replace a device in the server, you might have to either update the
firmware that is stored in memory on the device or restore the pre-existing firmware
from a diskette or CD image.
v IBM System x Server Firmware code is stored in ROM on the system board.
v
IMM firmware is stored in ROM on the IMM on the system board.
v
Ethernet firmware is stored in ROM on the Ethernet controller.
v ServeRAID firmware is stored in ROM on the ServeRAID adapter.
v
SATA firmware is stored in ROM on the integrated SATA adapter.
v SAS/SATA firmware is stored in ROM on the SAS/SATA adapter on the system
board.
Using the Setup utility
Use the Setup utility, formerly called the Configuration/Setup Utility program, to
perform the following tasks:
v
View configuration information
v
View and change assignments for devices and I/O ports
v
Set the date and time
v Set the startup characteristics of the server and the order of startup devices
v
Set and change settings for advanced hardware features
v View, set, and change settings for power-management features
v
View and clear error logs
v Resolve configuration conflicts
Starting the Setup utility
To start the Setup utility, complete the following steps:
1. Turn on the server.
Note: Approximately 20 seconds after the server is connected to AC power, the
power-control button becomes active.
2. When the prompt
<F1> Setup
is displayed, press F1. If you have set an
administrator password, you must type the administrator password to access the
full Setup utility menu. If you do not type the administrator password, a limited
Setup utility menu is available.
3. Select the settings to view or change.
Attention: If you set an administrator password and then forget it, there is no way
to change, override, or remove it. You must replace the system board.
Setup utility menu choices
The following choices are on the Setup utility main menu. Depending on the version
of the firmware, some menu choices might differ slightly from these descriptions.
v System Information
Select this choice to view information about the server. When you make changes
through other choices in the Setup utility, some of those changes are reflected in
the system information; you cannot change settings directly in the system
information.
This choice is on the full Setup utility menu only.
– System Summary
Chapter 6. Configuration information and instructions
303