IBM 7378, Problem Determination And Service Manual

Page: 207 / 362

Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
2. Touch the static-protective package that contains the disk drive to any unpainted
metal surface on the server; then, remove the disk drive from the package.
3. Remove the filler panel from the hot-swap drive bay, if one is installed.
4. Make sure that the tray handle is open; then, install the hard disk drive into the
hot-swap bay.
5. Rotate the drive handle down until the drive is seated in the hot-swap bay and
the release latch clicks into place.
Notes:
a. After you install the hard disk drive, check the disk drive status LEDs to
verify that the hard disk drive is operating correctly.
If the amber hard disk drive status LED is lit continuously, that drive is faulty
and must be replaced. If the green hard disk drive activity LED is flashing,
the drive is being accessed.
b. If the server is configured for RAID operation through an optional
ServeRAID adapter, you might have to reconfigure your disk arrays after you
install hard disk drives. See the ServeRAID documentation on the
IBM
ServeRAID Support CD for additional information about RAID operation and
complete instructions for using ServeRAID Manager.
6. Close the bezel.
Chapter 5. Removing and replacing server components
189