IBM 4002-Y2A, Installation And User Manual

Page: 62 / 96

Table 18. Supported XFP transceivers for 4002-Y2B and 4002-Y4B (continued)
10 Gigabit Optic Distance Supported for stacking
10GBase-ER 40km No
Table 19. Supported SFP transceivers for 4002-Y2A, Y4A, Y2C, and Y4C
10 Gigabit Optic Distance Supported for stacking
10GSFPP-SR 300km Yes
10GSFPP-LR 10km No
Note: Distances supported on -SR optics depends on type of multi-mode fiber
cabling used. OM3, 50 micometer (2000 MHz*km) fiber is required to
support maximum distances.
Installing a transceiver
You can install a new transceiver in an XFP, SFP, or SFP+ slot while the device is
powered on and running.
While installing a transceiver, wear an ESD wrist strap with a plug for connection
to a metal surface.
Note: For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
resistor.
CAUTION:
Data processing environments can contain equipment transmitting on
system links with laser modules that operate at greater than Class 1
power levels. For this reason, never look into the end of an optical fiber
cable or open receptacle. (C027)
Use the following steps to install a transceiver.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a
metal surface (such as an equipment rack) to act as ground.
2. Remove the new transceiver from the protective packaging.
3.
Gently insert the transceiver into the slot until it clicks into place. Transceivers
are keyed to prevent incorrect insertion.
36
Ethernet y-series Installation and User Guide: Installation and User Guide