IBM 4002-Y2A, Installation And User Manual

Page: 53 / 96

Installing an optional module on the 4002-Y2A, Y4A, Y2C, and Y4C
The 4002-Y2A, Y4A, Y2C, and Y4C switches support an optional four-port
100/1000 Mbps SFP module or four-port 10 Gbps SFP+ module. The 10 Gbps SFP+
module allows you to use your device in a stack. Figure 30 shows how to install an
optional SFP or SFP+ module.
Attention: The optional SFP and SFP+ modules are not hot-swappable. Be sure to
power-down your device before you install or replace a module.
Use the following procedure to install an optional module into the switch.
1.
Remove the blank metal plate (or a previously installed module) from the slot
by removing the two screws with a Phillips #2 screwdriver.
2. Before opening the module package, touch the bag to the switch casing to
discharge any static electricity. Using an ESD wrist strap during installation is
recommended.
3. Remove the module from the antistatic shielded bag.
4. Hold the module level, guide it into the carrier rails and gently push it into the
slot until it firmly engages with the connector.
5. When the module is engaged, tighten the retainer screws to secure the module
in the slot.
6.
Power on the switch by plugging in the power cords into the power supplies.
When the switch is powered on, the LEDs will follow the LED status as
described in “Port, system, and power status LEDs for the 4002-Y2A, Y4A, Y2C,
and Y4C” on page 10.
Note: The two left ports (ports <stack id>/2/1 and <stack id>/2/2) on the
four-port 10 Gbps SFP+ module do not pass regular Ethernet traffic by
default. If you want all four ports on the four-port 10 Gbps SFP+ module to
pass regular traffic the global CLI command,
stack disable , must be
configured on the device to disable stacking. For more information, see the
FastIron Configuration Guide .
Attention: If you do not install a module in a slot, you must keep the slot panel
in place. If you run the device with an uncovered slot, the system will overheat.
nety034
Figure 30. Installing an optional module on the 4002-Y2A, Y4A, Y2C, and Y4C
Chapter 2. Installing a y-series switch
27