IBM 4002-Y2A, Installation And User Manual

Page: 48 / 96

Powering on the system
After you have completed the physical installation, you can power on the system.
1. Remove the power cable from the shipping package.
2. Attach the AC power cable to the AC connector on the rear panel.
3. Insert the power cable plug into a 10A 120V or 240V outlet.
Notes:
1. To turn the system off, simply unplug the power cable or cables.
2. The socket should be installed near the equipment and should be easily
accessible.
3. If the outlet is not rated 10A 120V or 240V, stop and get the appropriate cable
for the outlet.
Attaching a PC or terminal
To assign an IP address, you must have access to the Command Line Interface
(CLI) . The CLI is a text-based interface that can be accessed through a direct serial
connection to the device and through Telnet connections. The CLI is described in
detail in the
FastIron Configuration Guide .
Access the CLI by attaching a serial cable to the Console port. After you assign an
IP address, you can access the system through Telnet, the Web management
interface, or IronView Network Manager.
Use the following steps to attach a management station to the serial port.
1.
Connect a PC or terminal to the serial port of the system using a
straight-through cable. The serial port has a male DB-9 connector. See Figure 25.
2. On the PC, launch a terminal emulation program and set the following session
parameters:
v
Baud: 9600 bps
v Data bits: 8
v
Parity: None
v
Stop bits: 1
v Flow control: None
The EIA or TIA 232 serial communication port serves as a connection point for
management by a PC or SNMP workstation. The y-series devices come with a
standard male DB-9 connector, shown in Figure 25.
net_com009
6 9
1 5
Figure 25. Serial port (DB-9 DTE) pin-out
22
Ethernet y-series Installation and User Guide: Installation and User Guide