IBM 4002-Y2A, Installation And User Manual

Page: 52 / 96

Installing an optional module on the 4002-Y2B and 4002-Y4B
The 4002-Y2B and 4002-Y4B switches support an optional two-port 10 Gbps
Ethernet XFP module. This module is hot-swappable / hot-installable, however a
reload
command is required to recognize the new ports. It is recommended that
the device be powered off prior to installing this module.
Use the following procedure to install an optional module into the switch.
1. Power off the device by removing all power cords connected to the power
supplies.
2. Remove the blank metal plate (or a previously installed module) from the slot
by removing the two screws with a Phillips #2 screwdriver.
3. Before opening the package that contains the module, touch the bag to the
switch casing to discharge any potential static electricity. Using an ESD wrist
strap during installation is recommended.
4. Remove the module from the antistatic shielded bag.
5.
Holding the module level, guide it into the carrier rails on each side and gently
push it all the way into the slot, ensuring that it firmly engages with the
connector.
6. When you are sure the module has properly engaged the connector, tighten the
retainer screws to secure the module in the slot.
7. Power on the switch by plugging in the power cords into the power supplies.
When the switch is powered on, the LEDs will follow the LED status as
described in “Port, system, and power status LEDs for the 4002-Y2B and
4002-Y4B” on page 8.
Attention: If you do not install a module in a slot, you must keep the slot panel
in place. If you run the device with an uncovered slot, the system will overheat.
nety034
Figure 29. Installing an optional module
26
Ethernet y-series Installation and User Guide: Installation and User Guide