IBM 4002-Y2A, Installation And User Manual

Page: 74 / 96

CAUTION:
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
resistor.
To remove a copper or fiber optic module from an SFP slot, do the following.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a
metal surface (such as an equipment rack).
2. Disconnect the copper or fiber cable connector from the port connector.
3. Unlock the copper or fiber optic module by pulling the bail latch forward,
away from the front panel of the module.
On 1000BaseSX ports, the bail latch is enclosed in a black sleeve, and on
1000BaseLX ports, the bail latch is enclosed in a blue sleeve.
1
Bail Latch
Note: The bail latch may be attached to either the top or the bottom of the
mini-GBIC.
4. Grasp the bail latch and pull the copper or fiber optic module out of the port.
5. Store the copper or fiber optic module in a safe, static-free place or in an
anti-static bag.
6. Install a new copper or fiber optic module in the port.
Cabling a fiber optic module
For instructions on cabling a fiber optic module refer to “Cabling a fiber optic
transceiver” on page 37.
Cleaning the fiber optic connectors
For instructions on cleaning a fiber optic module refer to “Cleaning the fiber optic
connectors” on page 37.
1
net_com008
Figure 35. Unlocking the bail latch
net_com002
Figure 36. Removing the fiber optic module
48
Ethernet y-series Installation and User Guide: Installation and User Guide