IBM 4002-Y2A, Installation And User Manual

Page: 50 / 96

When the device is powered on, the PSU AC and DC LEDs on the PSU back panel
should turn green to confirm that the PSU is correctly installed and supplying
power.
Attention: If you do not install a PSU in a slot, you must keep the slot panel in
place. If you run the device with an uncovered slot, the system will overheat.
Installing and replacing a fan tray on the 4002-Y2B and 4002-Y4B
The fan tray is hot-swappable and can be replaced while the device is powered on.
If the device remains operational during fan tray replacement the procedure must
be completed within 30 seconds.
To install a fan tray in the switch, do the following steps.
1. Remove the previously installed fan tray from the slot by removing the two
screws with a crosshead or Philips #2 screwdriver.
2. Before opening the package that contains the new fan tray, touch the bag to the
switch casing to discharge any potential static electricity. Using an ESD wrist
strap during installation is recommended.
3. Remove the fan tray from the antistatic shielded bag.
4. Holding the fan tray level, guide it into the carrier rails on each side and gently
push it all the way into the slot, ensuring that it firmly engages with the
connector.
5.
When you are sure the fan tray has properly engaged the connector, tighten the
retainer screws to secure the fan tray in the slot.
Note: The fans are controlled by software, and their speed is set according to the
environmental temperature surrounding the switch.
Installing and replacing a fan tray on the 4002-Y2A, Y4A, Y2C, and Y4C
Attention: For the 4002-Y2A, Y4A, Y2C, and Y4C devices, be sure that the airflow
direction of the power supply unit matches that of the installed fan tray. The
power supplies and fan trays are clearly labeled with an arrow with an “E” or an
"I", as shown in Table 2 on page 3.
nety031
Figure 27. Installing a fan tray on the 4002-Y2B and 4002-Y4B
24
Ethernet y-series Installation and User Guide: Installation and User Guide