IBA PQU-S, Manual, Page: 77 / 116

Manual
Issue 1.3
77
10.3.14 Flicker severity submodule
“General” tab
Figure 50: Flicker severity submodule
– “General” tab
Basic settings

See Power frequency submodule, “General” tab, chapter 10.3.2
Configuration

Lamp model
To calculate the flicker, the lamp model to be used, 230V or 120V, has to be speci-
fied.

Flicker input

Only voltages
For the calculation only voltages are being used.

Only currents
For the calculation only currents are being used. For this purpose, you need to
indicate for each conductor its impedance in Ohm.

Voltages and currents
The flicker for voltages and currents is calculated. For the current flicker calcula-
tion you need to indicate the impedance of the single conductors.