IAME X30 125cc RL - TaG, Assembly Instructions & User Manual

Page: 16 / 54

- 14 - MAN-043E ENG
2.7 INSTALL THE CLUTCH COVER WITH
H.T. COIL
5 mm ALLEN
2.7.1 REMOVE THE 3 SCREWS M6x25 ON THE
CRANKCASE (SEE FIG.10) AND INSTALL THE
CLUTCH COVER WITH H.T. COIL. (SEE FIG.11).
TORQUE THE 3 SCREWS AT 8 ÷ 10 Nm (70÷ 90
in-lb).
NOTE:
IF A HORIZONTAL MOTOR-MOUNT IS USED
CHECK AND SEE IF THERE IS SUFFICIENT SPACE
BETWEEN THE CHAIN AND THE UPPER PART OF
THE CLUTCH COVER. IF THIS IS LOWER THAN
6÷7 mm WIDEN THE CHAIN OPENING WITH A
FILE. TO CHECK THIS WE SUGGEST TO INSTALL
THE SPROCKET WITH THE HIGHEST AVAILABLE
TOOTH NUMBER
2.7.2 CONNECT THE COIL COPPER CABLE ON
THE HOLE ON THE CRANKCASE (SCREW
M6x12
(SEE FIG. 12).
TORQUE AT 8 ÷ 10 Nm (70 ÷ 90 in-lb)
WARNING:
ALWAYS MAKE SURE THAT THE GROUND
CABLE ALWAYS CONNECTS THE COIL WITH
THE ENGINE. AN INADEQUATE GROUNDING
COULD DAMAGE THE IGNITION BEYOND
REPAIR.
THE POSITION OF THE H.T. COIL HAS BEEN
CHOSEN TO BE AS FAR AS POSSIBLE FROM THE
EXHAUST AS THE EXCESSIVE HEAT COULD
DAMAGE THE COIL BEYOND REPAIR.
5 mm ALLEN
Fig.10
Fig.11
Fig.12