3-106
Convenient features of your vehicle
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before using the windshield wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the wiper and washer
system.
AUTO (Automatic) control
(if equipped)
The rain sensor located on the upper
end of the windshield glass senses
the amount of rainfall and controls
the wiping cycle for the proper inter-
val. The wiper operation time will be
automatically controlled depends on
rainfall.
When the rain stops, the wiper stops.
To vary the speed setting, turn the
speed control knob.
If the wiper switch is set in AUTO
mode when the ignition switch is in
the ON position, the wiper will oper-
ate once to perform a self-check of
the system. Set the wiper to the OFF
position when the wiper is not in use.
• When washing the vehicle, set
the wiper switch in the OFF (O)
position to stop the auto wiper
operation. The wiper may operate
and be damaged if the switch is
set in the AUTO mode while
washing the vehicle.
• Do not remove the sensor cover
located on the upper end of the
passenger side windshield glass.
Damage to system parts could
occur and may not be covered by
your vehicle warranty.
NOTICE
i
To avoid personal injury from
the windshield wipers, when the
engine is running and the wind-
shield wiper switch is placed in
the AUTO mode:
•
Do not touch the upper end of
the windshield glass facing
the rain sensor.
•
Do not wipe the upper end of
the windshield glass with a
damp or wet cloth.
•
Do not put pressure on the
windshield glass.
WARNING
Summary of Contents for ELANTRA 2019
Page 10: ......
Page 276: ...4 43 Multimedia System 4 NCC for Taiwan ...
Page 447: ...6 21 What to do in an emergency 6 JACKDOC14S EC Declaration of conformity for Jack ...
Page 557: ...I Index I ...