5-38
ASSEMBLY
In reassembling, have all parts washed, grease
applied to lubricating parts, and all expendable
items such as oil seal and spring washers
replaced by new ones.
Perform the disassembly in reverse order.
Tighten the set screw(10) of king pin(6).
There is a notch in the middle of the king pin(6),
make sure that this notch is on the set screw
side.
Do not hammer to drive in needle bearing(4)
because it will break.
Always use drive-in tool. In assembling the thrust
bearing(3), be sure that the fixed ring of the
bearing is placed in position facing the
knuckle(2).
Hub
Mount oil seal(28) and inner race of tapered
roller bearing(26) on the knuckle. The bearing
should be well greased before assembling.
Install the outer race of the bearing(27) in the
wheel center and assemble to the knuckle.
Put washer(29) in place, tighten with nut(31)
and locked with split pin(30). In locking with split
pin, locate the hole for the split pin by turning
the nut back 1/6 of a turn. Adjust the preload
of bearing.
Mount the hub cap(32).
Bearing should be well greased before assem-
bling.
4)
※
(1)
(2)
(3)
(4)
①
②
③
④
2
4
10
11
13
12
14
15
14
12
13
15
4
6
Notch
3
4~6kgf
Hub
27
29
30
31
32
26
28
D507SE38
Summary of Contents for 60L-7A
