5-27
Place the distributor plate so that the
channel holes match the holes in the
housing.
(23)
Guide the cardan shaft down into the bore
so that the slot is parallel with the
connection flange.
(24)
Screw the threaded bush lightly into the
check valve bore. The top of the bush
must lie just below the surface of the
housing.
(21)
Grease the O-ring with mineral oil approx.
viscosity 500 cSt at 20
°
C.
(22)
5-82(1)
5-82(2)
5-82(3)
5-82(4)
Summary of Contents for 60L-7A
