Hyundai 60L-7A, Manual

Page: 88 / 217

3-47
Clean every parts with cleaner and then remove remained loctite.
Be careful not to spill cleaner on your body.
Avoid drinking cleaner or breathing its fumes.
Wear protective clothing, glasses and gloves.
If spilled on the skin, flush your skin with water immediately.
If swallowed, get medical attention immediately.
·
Check wear, damage or crack for all the parts and replace if needed.
·
If the teeth of gear are damaged, replace it as a set.
·
Replace damaged tapered roller bearing.
·
Do not reuse deformed shims or worn thrust washers.
·
Polish the surface on which seal contacted if needed.
Adjusting shims of bevel pinion shaft.
Adjust shim thickness for the bevel pinion
shaft with following method.
Measure " E " distance on the housing.
By the equation " X = E - B - T
±
C + 0.25 ",
define the shim thickness(1).
B : Mounting dimension of bevel pinion
shaft , 131.10mm (5.2 in)
T : Height of bearing.
C : Dimension of carved seal on the
pinion. If there's no carved seal C =0.
EX) : From the housing
" E " = 162.85
mm
(6.4
in
)
B is factory dimension
" B " = 131.10
mm
(5.2
in
)
Front the bearing
"
T " = 31.75
mm
(1.5
in
)
Carved seal on the pinion
" C "= 0.05
mm
(0.002
in
)
Shim thickness :
"
X " = 162.85 -131.10 - 31.75 + 0.05
= 0.45
mm
(0.022
in
)
If teeth are damaged, replace it as a
set (bevel gear and shaft).
Do not reuse damaged shims and
bearings.
(1)
※
※
50D7EDA29
1) ADJUSTMENT OF BEVEL PINION SHAFT
①
②
4. REASSEMBLY OF DRIVE AXLE
50D7EDA30