Hyundai 60L-7A, Manual

Page: 202 / 217

8-4
GROUP 2 OPERATIONAL CHECKS AND TROUBLESHOOTING
1. OPERATIONAL CHECKS
FORKS
Measure thickness of root of forks and
check that it is more than specified value.
EX :
ℓ
=1200mm(47in)
1)
(1)
Thickness
Set forks in middle and measure out of
parallel and difference in height at the top of
forks. 2)
STD Fork assy Applicable model
60/70L-7A F14710111
Standard
65(2.6)
Limit
59(2.3)
mm(in)
2. MAST
Check for cracks at mast stay, tilt cylinder bracket, guide bar, fork carriage and roller shaft weld.
Check visually or use crack detection method. Repair any abnormality.
Set mast vertical, raise forks about 10cm from ground and check front-to-rear clearance and left-to-
right clearance between inner mast and fork carriage, and between outer mast and inner mast.
Use these figures to judge if there is any play at roller or rail.
·
Front-to-rear clearance : Within 2.0mm(0.08in)
·
Left-to-right clearance : Within 2.5mm (0.10in)
Check that there is an oil groove in bushing at mast support.
Set mast vertical, raise forks about 10cm from ground, and push center of lift chain with finger to
check for difference in tension.
If there is any difference in tension, adjust chain stopper bolt.
Check visually for abnormalities at thread of chain anchor bolt, and at contact surface between
chain wheel and chain.
Rotate chain wheel by hand and check for any play of bearing.
1)
2)
3)
4)
5)
D507FK01
Most force is concentrated at root of fork
and at hook, so use crack detection method
to check cracks. 3)
Difference in height
at tip of forks
D255FK02
equal or
below 1200
above 1200
3mm
Model Fork length
Height
difference
All
6mm