![background image](http://html1.mh-extra.com/html/hyundai/250d-9/250d-9_manual_2197489219.webp)
9-5
Trouble symptom
Trouble symptom
4. Unusual oil pressure
4. Unusual oil pressure
1) Oil pressure is high
2) Oil pressure is low
3) Transmission
·
Control valve malfunctioning.
·
Cold weather. (high oil viscosity)
·
Use of improper oil.
·
Gear pump malfunctioning (worn).
·
Oil leaks excessively :
(1) Control valve oil spring defective.
(2) Control valve spool defective.
·
Air sucked in.
·
Low oil level.
·
Oil filter clogging.
·
Oil leaks excessively.
(1)Check for spool operation.
If necessary, replace valve.
(2)Check for clogging of small hole in
valve body. If necessary, clean or
repair.
·
When atmospheric temp is below fr-
eezing point
(when normal oil pressure is recover-
ed if heated to 60~80˚C), change oil.
·
Check and change oil.
·
Disassemble, check and replace.
·
Check spring tension (see spring sp-
ecification).
If necessary replace.
·
Disassemble, check, and repair or re-
place valve.
·
Check joints and pipes. If necessary,
retighten joint or replace packing.
·
Check oil level and add oil.
·
Check and replace.
·
Disassemble, check (piston ring and
O-ring for wear and other defects),
and replace.
Probable cause
Probable cause
Remedy
Remedy
5. Power is not transmitted
5. Power is not transmitted
1) Torque converter
2) Transmission
·
Clutch plate damaged.
·
Low oil level.
·
Oil pump driving system faulty.
·
Shaft broken.
·
Lack of oil pressure.
·
Low oil level.
·
Inching valve and link lever improper-
ly positioned.
·
Forward/reverse spool and link lever
improperly positioned.
·
Clutch fails to disengage :
(1) Clutch case piston ring defective.
(2) Main shaft plug slipping out.
·
Clutch seizing.
·
Shaft broken off.
·
Clutch drum damaged (spring groove).
·
Clutch snap ring broken.
·
Check for damage by listening to ab-
normal sounds at a low converter sp-
eed and replace.
·
Check oil level and add oil
·
Disassemble and check for wear of
pump gear, shaft and spline.
Replace defective parts.
·
Check and replace.
·
Check oil pump gear for wear and for
oil suction force.
If necessary, replace pump.
·
Check oil level and add oil.
·
Check measure and adjust.
·
Check and adjust.
·
Disassemble, check and replace
·
Disassemble, check and repair or re-
place
·
Check to see whether or not machine
moves even then transmission is in
neutral position. If so, replace.
·
Disassemble, check(main shaft, etc.),
and replace.
·
Disassemble, check and replace.
·
Disassemble, check and repair or re-
place.