3-13
This lamp comes ON when the main light switch is operated to
2nd step.
Η
Head light pilot lamp
(3)
When the inching switch is pressed, the lamp lights ON.
Η
This lamp lights ON when start switch is turned clockwise to the
ON position. Light will turn off after approximately 15~45
seconds, depending on engine coolant temperature, indicating
that preheating is completed.
When the lamp goes out the operator should start cranking the
engine.
Refer to page 5-12.
Η
Θ
ö
Preheater pilot lamp
(4)
Inching pilot lamp
(5)
50D9CD07
50D93CD14
50D93CD65
50D93CD43
Fuel warmer pilot lamp
(6)
50D9CD14
OPSS pilot lamp
(7)
This signal lamp lights ON when the operator leaves the seat.
Powered travel movement of the truck shall be possible only if
the operator is in the normal operating position. Transmission
will automatically shift to neutral upon the exiting of the operator.
The gear selector lever must be cycled through neutral with the
operator in the normal operating position to regain powered
direction control.
Η
Θ
Ι
Illuminates when the hydraulic fluid temperature is below 20
¶
C
(68
¶
F) or engine coolant temperature is below 10
¶
C (50
¶
F).
If the engine coolant temperature is above 60
¶
C (140
¶
F) or
hydraulic fluid temperature is above 45
¶
C (113
¶
F) the start
switch is in the ON position, automatic fuel heating is canceled.
Η
Θ
