![background image](http://html1.mh-extra.com/html/hyundai/250d-9/250d-9_manual_2197489194.webp)
1
2
3
4
5
3
6
1 Adjust cylinder(2EA)
2 Fork(2EA)
3 Tilt cylinder(Left/Right, 2EA)
4 Lift chain(2EA)
5 Mast support(Left/Right, 2EA)
6 Steering axle(5EA)
7
7 Hydraulic pump drive spline(1EA)
7-46
Lubrication points
Lubrication points
Adjust cylinder : 2EA
Forks : 2EA
Tilt cylinder : Left/Right, 2EA
Lift chain : 2EA
Mast support : Left/Right, 2EA
Steering axle : 5EA
Hydraulic pump drive spline : 1EA
(3)
(3)
250D9OP17(1)
LUBRICATION
LUBRICATION
Supply grease through the grease nipple, using
grease gun.
After lubricating, clean off spilled grease.
Press the parking brake switch and fix front
Press the parking brake switch and fix front
and rear tires with blocks.
and rear tires with blocks.
Set the mast and forks in a stable position
Set the mast and forks in a stable position
and turn the hydraulic safety lock valve into
and turn the hydraulic safety lock valve into
the lock position.
the lock position.
(1)
(2)
35)
35)
①
②
③
④
⑤
⑥
⑦
Pin
Cylinder
250D7MS07
FORKS REPLACEMENT
FORKS REPLACEMENT
Lower the fork carriage until the forks are
approximately 25 mm (1 in) from the floor.
Take out the spring pin and remove the pin weld
assy.
Remove only one fork at a time.
On larger forks it may be necessary to use a block
of wood.
Reverse the above procedure to install load forks.
①
②
③
※
④
36)
36)