1
2
3
4
5
3
6
1 Adjust cylinder(2EA)
2 Fork(2EA)
3 Tilt cylinder(Left/Right, 2EA)
4 Lift chain(2EA)
5 Mast support(Left/Right, 2EA)
6 Steering axle(5EA)
7
7 Hydraulic pump drive spline(1EA)
5-32
BEFORE STORAGE
When you keep your forklift truck in storage for an
extended period of time, observe the following
safeguard instruction:
Wash and tidy the truck and house it in a dry
building.
When the truck has to be placed outdoors, park
it on a even ground and cover it securely with
canvas.
Give enough fuel, grease, lubricant and oil.
Coat exposed piston rods of all hydraulic
cylinders fully with grease.
Cover batteries after removing terminals, or
remove battery from the truck and store
separately.
W h e n t h e a t m o s p h e r i c t e m p e r a t u r e i s
anticipated to drop below 0˚C, add antifreeze.
Refer to COLD WEATHER OPERATION
about ratio of water and antifreeze.
14. STORAGE
1)
(1)
(2)
(3)
(4)
(5)
(6)
ö
DURING STORAGE
Operate the engine and move the truck for a
short distance once a month so that a new oil
film will be coated over movable parts and
component surfaces. Remove and storage the
battery at the same time.
The above operations should be performed in
the open. If they have to be performed inside
a building, open the windows and doors to
improve ventilation.
This is to avoid the danger of gas poisoning.
2)
(1)
AFTER STORAGE
After storage (When it is kept without cover or the rust-preventive operation once a month is not
carried out), you should apply the following treatment before operation.
Remove the drain plugs from the oil pan and other cases and drain any water.
Remove the rocker housing cover and lubricate the valves and rocker arms well. Inspect the
valve operation.
After the engine is started, run it at idling speed until it is warmed up completely.
3)
(1)
(2)
(3)
250D9OP17(1)
Lubrication
operation once
a month
250D9OP22
BATTERY
Once a month, start the engine for 15 minutes (or use a charger) to charge the battery.
Every 2 months, check the battery voltage and keep battery voltage over 25.08V.
If the machine stock period is over 6 months, disconnect the battery negative (-) terminal.
ö
刮
刯
到
