Calibration Menu
INTRODUCTION
The Calibration Menu is a main menu (top-level
menu) that is visible at Service Technician, Super-
visor, and Operator password access levels. The
Calibration Submenus and Icons topic shows the
icons displayed on calibration screens. To access
this menu, cycle through the main menu title
screens by pressing the Scroll Back Key (?—) or
Scroll Forward Key (—?) until the Calibration
Title Screen is displayed, as shown in Figure 29.
Figure 29. Calibration Title Screen
Press the Enter Key (*) to enter the Calibration
Menu and the system will display the first sub-
menu in the Calibration Menu, the Load Weight
Display submenu, which is shown in Figure 30.
Press the Enter Key again if you want to enter
this submenu. If you want a different submenu, use
the Scroll Back Key or Scroll Forward Key to
move to another submenu and press the Enter
Key.
Figure 30. Load Weight Display Submenu
The Calibration Menu presents these submenus:
• Load Weight Display
• Return to Set Tilt Stop Point
• E-Hydraulic Valves
• Steering Wheel Knob Center Point
• Steer Axle Position
• Manual Hydraulics
The following sections describe the Calibration sub-
menus.
2200 SRM 1336
Calibration Menu
79
Summary of Contents for A1.3-1.5XNT
