6. Read the End User License Agreement and, if you agree to the terms, click, “
I accept”
(bottom of
page).
7.
Save the START< >_setup.exe file to your desktop.
8.
Double-click the file to begin the installation.
9. Click RUN. A setup window appears.
s
oftWare
m
aIntenanCe
The software on the SDC board is periodically being enhanced with new features that create an easier install
and improve the on board diagnostic tools. Be sure to check the HySecurity website for the latest version of
software and operator code before heading out for field maintenance.
e
leCtrICal
C
ontrols
CAUTION
Before servicing, turn off all power switches.
No routine maintenance is needed for the electrical system or controls. If the environment is very sandy or
dusty, or has many insects, be certain to seal all holes in the electrical enclosure. Blow the dust out of the
electric panel with compressed air. Use the
Table 8: Troubleshooting Codes on page 60
to assess and fix
error, alert, and fault codes. If it is necessary to call a distributor for assistance, be sure to have your model and
serial number ready. Other helpful information includes the name of the job, approximate date of installation,
software version, and the service record of the operator, especially if any work has been done recently.
Clock Battery Replacement
A lithium coin battery supports the clock, so the date and time is retained even
when the main power is turned off. Replace the battery about every two years
(or as needed) with a DL 2025, DL 2032, or CR 2025, or CR 2032 battery.
Fuse Replacement
A 35A fuse is located next to the 24VDC power supply inputs on the SDC. It requires no maintenance, but if
it were blown due to a power surge or other unusual circumstance, it must be swapped out with a new fuse.
The symptoms of a blown fuse appear as a control system malfunction (i.e. all control systems may not work
properly).
COM A
COM NO
DC
Battery
COM
COM
24VDC
24VDC
Fuse
72
MX3650-01 Rev. D
StrongArmPark DC Programming & Operations
© 2017
www.hysecurity.com
