Hypertherm EcoSift, Operator'S Manual

Page: 50 / 188

Operation
Operat
io
n
50 EcoSift Operator Manual 809500
Turn OFF the EcoSift
Routine stop
On the home screen (RUNNING PAGE), touch
O
to turn
OFF
the EcoSift.
The EcoSift does a normal shutdown.
1. The abrasive pump turns off.
2. The feed pump water hoses are cleared.
3. After 10 minutes, the heating elements turn off.
DANGER
Dangerous voltage/risk of shock
To decrease the risk of serious injuries or death, wear approved protection and obey safety
recommendations when working with electricity.
DANGER
• Personnel who maintain and repair this machinery can be seriously injured or killed if hazardous
energy is not controlled. Injuries can include burns, cuts, fractures, or electrocution.
• Disconnect and lock out the electric power supply before opening the electrical enclosure or
doing maintenance or repair procedures.
• Isolate all sources of electric, mechanical, hydraulic, pneumatic, chemical, thermal, and other
energy with a lockable energy-isolating device that meets local and national requirements.
Refer to
Safety
on page 66.
DANGER
• Personnel who work on deenergized machinery can be seriously injured or killed if the machinery
is reenergized without permission.
• All personnel must respect lock-out devices. Only the person(s) who applied the devices shall
remove them.
• All personnel in an area where energy-control procedures are used must receive training
regarding the energy-control procedure and the prohibition against removing a lock-out device.
WARNING
Wear approved personal protective equipment such as goggles, gloves, and respirators when
operating or working near this machinery. Refer to
Personal protective equipment
on page SC-20.